Ultrafiltration Unit IMT-U5
H2O nanotec IMT-U5 whole-house ultrafiltration – clean water for the whole household without electricity. The unit is installed on the main water supply and its 0.01 µm membrane physically removes bacteria, viruses, sludge, rust and microplastics. With a flow rate of 2,000 l/h, it is suitable for family houses with lower water consumption as well as for commercial premises.
Key benefits of H2O nanotec IMT-U5 ultrafiltration
- Physically removes bacteria including E. coli, viruses, sludge and rust
- Captures microplastics, while minerals stay in the water
- A more effective alternative to a UV lamp – works without electricity and without bulb replacement
- Filters all the water in the house and copes with simultaneous use at several points
The heart of the unit is a hydrophilic PAN (polyacrylonitrile) membrane with 0.01 µm pores in a brushed 304 stainless steel housing. It runs on mains water pressure alone and flushes captured impurities to the drain.
Technical highlights of IMT-U5 ultrafiltration
- 2,000 l/h flow rate for the whole household
- 0.01 µm PAN membrane, life up to 36 months
- No electricity needed, operating pressure 0.1–0.4 MPa
- G3/4" connection, 304 stainless steel housing
| Category: | Ultrafiltration |
|---|---|
| Warranty: | 2 years |
| Weight: | 9.3 kg |
| Filter type: | Ultrafiltration |
| Installation location: | Under the sink, Whole house (main supply) |
| Place of use: | For households, For wells / cottages, For businesses and catering |
| Water problem: | Coliform bacteria, E. coli, viruses, Microplastics |
Why use whole-house ultrafiltration?
Both well water and mains water can contain bacteria, viruses, sludge or rust, and in recent years also microplastics. These impurities end up in your drinking water, shower and appliances.
The IMT-U5 ultrafiltration unit captures them on a membrane with 0.01 µm pores before the water is distributed around the house.
Unlike a UV lamp or chlorination, it does not merely inactivate microorganisms – it physically removes them from the water, including dead cells. Minerals such as calcium and magnesium remain in the water.
How does IMT-U5 ultrafiltration work?
Driven by mains pressure, water flows through the ultrafiltration membrane. Clean water passes through, impurities stay on the membrane surface and are carried to the drain during flushing.
Filtration includes:
- 0.01 µm PAN membrane – hydrophilic polyacrylonitrile resistant to biofouling, captures bacteria, viruses, sludge, rust and microplastics.
- Membrane flushing – captured impurities are flushed to the drain. Frequent flushing extends membrane life.
- Recommended pre-filter – an IMT-M5 pressure regulator with pre-filter or IMT-M8 upstream of the unit captures coarse impurities and significantly extends membrane life.
The IMT-U5 needs no electricity, chemicals or UV bulb replacement. It runs on household mains pressure of 0.1–0.4 MPa alone.
What does the IMT-U5 help remove from water?
A membrane with 0.01 µm pores reliably captures particles and microorganisms larger than its pores:
- bacteria including E. coli and coliform bacteria,
- viruses,
- sludge, rust, sediments and algae,
- microplastics.
Notice: Ultrafiltration does not remove dissolved substances – pesticides, pharmaceuticals, hormones, heavy metals, nitrates or water hardness – and may not reliably capture the smallest nanoplastic particles. For dissolved substances, nanofiltration at the drinking water tap is suitable; for hard water, a water softener.
Who is IMT-U5 whole-house ultrafiltration suitable for?
The IMT-U5 is designed for buildings where you want clean water at every tap, in the shower and for your appliances.
IMT-U5 ultrafiltration is especially appreciated by:
- owners of family houses with a well,
- households bothered by sludge and rust from the mains,
- family houses with lower water consumption,
- commercial premises.
The effectiveness of water treatment always depends on the water's composition. For well water, we recommend having it analysed first – we will be happy to help you evaluate the results.
Why the IMT-U5 instead of a UV lamp?
A UV lamp inactivates microorganisms with radiation, but their bodies remain in the water. It needs electricity, regular bulb replacement and radiation intensity checks, and it does not capture sludge or microplastics.
IMT-U5 ultrafiltration physically removes bacteria and viruses, also captures mechanical impurities and works without electricity.
| IMT-U5 vs. UV lamp | ||
|---|---|---|
| IMT-U5 | UV lamp | |
| Bacteria and viruses | physically removes | inactivates, they remain in the water |
| Sludge, rust, microplastics | captures | does not capture |
| Electricity | not needed | required |
| Regular maintenance | membrane flushing | bulb replacement, radiation checks |
| Minerals in water | preserved | preserved |
Installing IMT-U5 ultrafiltration
The unit is installed solely on the main water supply where it enters the building (point of entry), so it filters all the water from one place. It can be wall-mounted in any position, so it easily fits the space in your utility room.
Installation steps:
- Close the main water supply.
- We recommend fitting an IMT-M5 or IMT-M8 pressure regulator with pre-filter upstream of the unit.
- Connect the IMT-U5 to the supply (G3/4" connection) according to the installation manual. We also recommend fitting a bypass so that water can be routed around the filter during maintenance.
- Connect the flushing outlet to the drain.
- Slowly open the water, check for leaks and carry out the first flush.
We recommend having a plumber install the unit on the main supply – see also DIY installation.
Will the IMT-U5 affect water pressure or flow?
The 2,000 l/h (33.3 l/min) flow rate covers the needs of a family house with lower water consumption, including simultaneous use at several points – for example the shower, washing machine and kitchen tap at the same time. Pressure loss with a new membrane is small. As the membrane gradually clogs, the flow may drop – regular flushing restores it.
If you need a higher flow rate, choose IMT-U7 ultrafiltration with a flow rate of 3 m³/h for a standard family house or flat, or IMT-U8 ultrafiltration with a flow rate of 4 m³/h for guesthouses, hotels or businesses.
How to care for the IMT-U5 and when to replace the membrane?
The PAN membrane lasts up to 36 months, depending on the quality of the incoming water. Regular flushing removes captured impurities and extends its life.
Consider replacing the membrane if:
- approximately 36 months of operation have passed,
- the flow has dropped significantly even after flushing,
- the quality of the filtered water has deteriorated.
An IMT-M5 or IMT-M8 pressure regulator with pre-filter significantly extends membrane life. We will be happy to advise you on replacing the membrane.
Clean water throughout the house without electricity
IMT-U5 ultrafiltration protects the water throughout the building – from the kitchen to the bathroom. It physically removes microorganisms and mechanical impurities and leaves minerals in the water.
Thanks to operation without electricity and long membrane life, it is an economical and reliable solution for family houses and commercial premises alike.
Main advantages of IMT-U5 ultrafiltration
- 0.01 µm membrane,
- removes bacteria and viruses,
- captures sludge, rust and algae,
- captures microplastics,
- preserves minerals,
- 2,000 l/h flow rate,
- no electricity needed,
- membrane life up to 36 months,
- 304 stainless steel housing,
- UV lamp replacement.
| Technical specifications | |
|---|---|
| Model | IMT-U5 |
| Product type | whole-house ultrafiltration unit |
| Membrane | PAN (polyacrylonitrile), 0.01 µm |
| Flow rate | 2,000 l/h (33.3 l/min) |
| Connection | G3/4" |
| Inlet pressure | 0.1–0.4 MPa |
| Operating temperature | 5–38 °C |
| Membrane life | up to 36 months |
| Dimensions | 695 × 152 × 157 mm |
| Weight | 9.3 kg |
| Housing material | 304 stainless steel |
| Electricity | not needed |
| Certification | CE, RoHS |
| Package contents |
|---|
| 🟢 IMT-U5 filtration unit |
| 🟢 Installation manual |
⚠ NOTE: A drain for membrane flushing is required at the installation site.
FREQUENTLY ASKED QUESTIONS
Everything you need to know about IMT-U5 ultrafiltration
What is the IMT-U5 and what is it for?
The IMT-U5 is a whole-house ultrafiltration unit with a membrane with 0.01 µm pores and a flow rate of 2,000 l/h. It is installed on the main water supply and filters all the water in the building. It removes bacteria, viruses, algae, sludge, rust, sediments and microplastics and keeps minerals such as calcium and magnesium in the water.
What is the difference between the IMT-U5, IMT-U7 and IMT-U8?
All three units use a 0.01 µm PAN membrane and are installed on the main water supply. They differ in flow rate: the IMT-U5 has 2,000 l/h and is designed for family houses with lower water consumption, while still coping with simultaneous use at several points. The IMT-U7 with 3 m³/h is designed for standard family houses and flats, and the IMT-U8 with 4 m³/h for buildings with higher consumption, such as guesthouses, hotels or businesses.
What is the difference between the IMT-U5 and IMT-U4? Can the IMT-U5 be installed under the sink?
The IMT-U5 is designed solely for installation on the main water supply (point of entry) and cannot be installed under the sink. The smaller IMT-U4 with a flow rate of 1,000 l/h can be installed both under the kitchen sink and at the point of entry. The IMT-U5 has twice the flow rate, 2,000 l/h, and is suitable for households with higher water consumption.
Will the IMT-U5 replace a UV lamp?
Yes. A UV lamp only inactivates bacteria and viruses, and their bodies remain in the water. IMT-U5 ultrafiltration physically captures microorganisms and removes them from the water, including dead cells. It also works without electricity and without replacing UV bulbs.
Will the IMT-U5 remove E. coli and coliform bacteria from well water?
Yes. The membrane has 0.01 µm pores, while E. coli bacteria measure 0.5–5 µm – so they are 50 to 500 times larger than the membrane pore. The bacteria are physically captured and removed from the water. Read more in the article How to Remove Coliform Bacteria and E. coli from a Well.
How does IMT-U5 ultrafiltration differ from IMT-NC9 nanofiltration?
The IMT-U5 (0.01 µm) removes bacteria, viruses, sludge and microplastics, but not dissolved substances such as pesticides, pharmaceuticals, hormones or heavy metals. IMT-NC9 or IMT-RS8 NANO membrane nanofiltration (0.001 µm) removes them, but it is an under-sink solution for a single drinking water tap. For maximum protection, the two systems can be combined.
Is the IMT-U5 suitable for well water?
Yes. The IMT-U5 reliably removes bacteria, viruses, algae, sludge and sediments typical of well water. If the water also contains pesticides, nitrates or heavy metals, we recommend adding nanofiltration at the drinking water tap. We will be happy to advise you based on a water analysis.
How long does the IMT-U5 membrane last?
The PAN membrane lasts up to 36 months, depending on the quality of the incoming water. An IMT-M5 or IMT-M8 pressure regulator with pre-filter upstream of the unit and regular membrane flushing significantly extend its life.
Does the IMT-U5 need electricity or a booster pump?
No. The IMT-U5 runs on household mains pressure of 0.1–0.4 MPa alone and needs no electricity or booster pump. This makes it inexpensive to run and silent.
Do I need a drain for the IMT-U5?
Yes. Captured impurities are flushed from the membrane to the drain, so a drain must be available at the installation site.
🔬 How ultrafiltration works: The effectiveness of ultrafiltration in removing E. coli and coliform bacteria from well water has been described by RNDr. Jiří Polman CSc., Managing Director of H2O nanotec, with reference to scientific literature (LeChevallier et al., Applied and Environmental Microbiology, 1988). Read more on the H2O nanotec blog: How to Remove Coliform Bacteria and E. coli from a Well.
Didn't find your answer? Ask us directly — we reply Mon–Thu 8 am–4 pm, Fri 8 am–2 pm (CET).
Product rating
Be the first who will post an article to this item!
Discussion
Be the first who will post an article to this item!
